Hydraulic tests on the nuclear reactor pressure vessel of unit 2 of the under-construction Rooppur Nuclear Power Plant has been completed. Atommash – part of Atomenergomash, the engineering division of Russian state nuclear corporation Rosatom – carried out the tests. The hydraulic tests were performed in a three-level underground caisson test bench. To install the reactor pressure vessel in the design position, a supporting ring was first installed on the test bench, and then a VVER-1200 reactor pressure vessel was placed on it. The equipment was moved using an overhead crane with a lifting capacity of 600 tonnes. Also read: Reactor pit construction at Rooppur NPP power unit No.1 completed The reactor pressure vessel with a height of 11 metres was lowered into the caisson with high precision and closed with a process cover, Rosatom said. After creating a complete sealing, the item was filled with distilled water, heated to 65 degrees, created a maximum pressure (24.5 MPa) – 1.4 times higher than the working pressure and held for 10 minutes. The hydraulic tests of the reactor pressure vessel of unit 2 of the Rooppur Nuclear Power Plant confirmed the tightness of the base metal and the weld joints of the reactor pressure vessel. The Russian contractor said, "The reactor is a vertical cylindrical vessel with an elliptical bottom, inside which the core and internals are located." Also read: FM, senior MoFA officials visit Rooppur Nuclear Power Plant The top of the reactor is hermetically sealed with a cover with drives of mechanisms and controls and protection of reactors installed on it and nozzles for outputting cables of sensors for the in-core monitoring. The Rooppur Power Plant is being designed and built according to a Russian project. The design and construction of the facility are carried out by the engineering division of Rosatom. The plant will consist of two power units with VVER-1200 reactors, the life cycle of which is 60 years with the possibility of extending the service life for another 20 years.